Hybrid Racing Mejora de cilindro maestro de embrague (Civic 17-21 2.0 Turbo Type R FK8)
80% de los productos en nuestra tienda están en stock interno o externo, lo que nos permite procesar tu pedido con prontitud (entre unas pocas horas y varios días laborables).
Evidentemente, es posible que un producto tenga un plazo de entrega (inesperadamente) más largo.
Después de recibir tu pedido, te informaremos al respecto y, si es necesario, te ofreceremos alternativas disponibles. Mantén un buen control sobre tu buzón de correo.
Proporcionamos información de stock deliberadamente después de realizar tu pedido, ya que muchos proveedores no disponen de un sistema que permita sincronizar estos datos. Además, no queremos mostrar “estimaciones” como muchas otras tiendas online, donde finalmente acabas recibiendo un plazo diferente o más largo del que se indicaba inicialmente.
Queremos darte únicamente información real y actualizada en el momento en que procesamos tu pedido, para evitar cualquier forma de confusión o desinformación.
¿Necesitas un producto con urgencia y quieres estar seguro de que lo tenemos en stock?
Envíanos un correo electrónico, llámanos o utiliza el botón "haz una pregunta sobre este producto" que encontrarás debajo de la descripción del artículo.
The Hybrid Racing kit for FK8 is a straightforward bolt-on part that includes an OE Nissin CMC, a stainless braided clutch line with fittings, and stand-offs for mounting the clutch line. No additional replacement parts or parts from the factory CMC or SLV are required. The kit has the necessary grease to lubricate the clevis pin and prevent NVH (noise, vibration, and harshness).
The OE Nissin CMC used in the kit has an aluminum piston body compared to the plastic assembly in older models. The plastic assembly has the potential to deflect in racing conditions or by using a stronger pressure plate.
In 2002, Honda introduced a damper and delay valve in the clutch hydraulic system for US models with K-series powertrains. The damper in the CMC body casting, identified by the external triangular section, reduces vibrations transmitted to the clutch pedal, minimizing cabin NVH and vehicle feedback.
We remove this damper to enhance the connection to the powertrain, resulting in increased pedal feedback and consistency at higher engine speeds and loads. This more direct connection is preferred by drivers and racers alike.
Upgrading to our CMC kit will improve the pedal feel. However, it can make the entire system slightly more noisy under normal conditions.
TECHNICAL DATA
- Master Cylinder with clevis installed and pre-calibrated to OE FK8 specs.
- Plated steel clevis
- Clutchline: The clutch line in the kit replaces hard and soft lines between the master cylinder and the slave cylinder. Included are mounting hardware for the factory transmission point and two standoff clips for mounting the line to Driver Side frame rail.
- Spacer: the studs on the HR CMC have extended shoulders, so spacers are included to ensure thread engagement.
- A neoprene firewall seal is included to prevent water and debris entering the cabin.
- A 1oz packet of PTFE grease will be used on the pin that holds the clevis to the clutch pedal. The grease will reduce NVH from being produced at the pedal assembly.
CLICK TO VIEW THE INSTALL GUIDE
